Diagnosis Procedure

1. Turn ignition switch ON.
2. Select the "Data Monitor" for the "TRANSMISSION" and check the "DRIVE MODE STATS" monitor value.

   Condition	Value
   When the SPORT mode switch is pressed.	SPORT ↔ NORMAL

Is the inspection result normal?

YES

GO TO 7 .

NO

GO TO 2 .

1. Check voltage between A/C auto amp. harness connector terminals.

   A/C auto amp.		-	Condition	Voltage (Approx.)
   Connector	+
   	Terminal
   M37	31	Ground	Drive mode selector: SPORT switch ON	0 V
   			Drive mode selector: SPORT switch OFF	12 V

Is the inspection result normal?

YES

Replace TCM. Refer to Removal and Installation .

NO

GO TO 3 .

1. Turn ignition switch OFF.
2. Disconnect drive mode selector connector.
3. Check the continuity between drive mode selector harness connector and ground.

   Drive mode selector		--	Continuity
   Connector	Terminal
   M264	12	Ground	Existed

Is the inspection result normal?

YES

GO TO 4 .

NO

Repair or replace damaged parts.

1. Disconnect A/C auto amp. connector.
2. Check continuity between A/C auto amp. harness connector terminals and drive mode selector harness connector terminals.

   A/C auto amp.		Drive mode selector		Continuity
   Connector	Terminal	Connector	Terminal
   M37	31	M264	9	Existed

Is the inspection result normal?

YES

GO TO 5 .

NO

Repair or replace damaged parts.

Check continuity between A/C auto amp. harness connector terminal and ground.

Is the inspection result normal?

YES

GO TO 6 .

NO

Repair or replace damaged parts.

Check drive mode selector. Refer to Component Inspection .

Is the inspection result normal?

YES

Replace A/C auto amp. Refer to Removal and Installation .

NO

Replace drive mode selector. Refer to Removal and Installation .

Select the "Data Monitor" for the "METER/M&A" and check the "SPORT IND" monitor value.

Is the inspection result normal?

YES

Replace TCM. Refer to Removal and Installation .

NO

Replace combination meter. Refer to Removal and Installation .