Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2018 >> Versa Note SR >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (DTC/Circuit Diagnosis) (2 Of 3) >> DTC/Circuit Diagnosis >> DTC P0441: EVAP Control System >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    Will CONSULT be used?

    YES

    GO TO 2 .

    NO

    GO TO 5 .

  2. PERFORM DTC CONFIRMATION PROCEDURE-I 

    SYMBOL WITH CONSULT

    TESTING CONDITION:

    Always perform test at a temperature of 5°C (41°F) or more.

    1. Start engine and warm it up to normal operating temperature.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Turn ignition switch ON.
    4. Turn ignition switch OFF and wait at least 10 seconds.
    5. Start engine and let it idle for at least 70 seconds.
    6. Select "PURG FLOW P0441" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode of "ENGINE" using CONSULT.
    7. Touch "START".

    Is "COMPLETED" displayed on CONSULT screen?

    YES

    GO TO 4 .

    NO

    GO TO 3 .

  3. PERFORM DTC CONFIRMATION PROCEDURE-II 

    When the following conditions are met, "TESTING" will be displayed on the CONSULT screen. Maintain the conditions continuously until "TESTING" changes to "COMPLETED". (It will take at least 35 seconds.)

    Selector lever

    Suitable position

    VHCL SPEED SE

    32 - 120 km/h (20 - 75 MPH)

    ENG SPEED

    500 - 3, 800 rpm

    B/FUEL SCHDL

    1.0 - 10 msec

    COOLAN TEMP/S

    More than 0°C (32°F)
    CAUTION: Always drive vehicle at a safe speed.
    NOTE: If "TESTING" does not change for a long time, retry from step 2.

    Is "COMPLETED" displayed on CONSULT screen?

    YES

    GO TO 4 .

    NO

    Perform DTC CONFIRMATION PROCEDURE again. GO TO 2 .

  4. PERFORM DTC CONFIRMATION PROCEDURE-III 

    Touch "SELF-DIAG RESULTS".

    Which is displayed on CONSULT screen?

    OK

    INSPECTION END

    NG

    Proceed to Diagnosis Procedure .

  5. PERFORM COMPONENT FUNCTION CHECK 

    SYMBOL WITH GST

    Perform component function check. Refer to Component Function Check .

    NOTE: Use component function check to check the overall monitoring function of the EVAP control system purge flow monitoring. During this check, a 1st trip DTC might not be confirmed.

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Proceed to Diagnosis Procedure .

scientia non olet · About Mike's Workshop Manuals