DTC Confirmation Procedure

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF and wait at least 10 seconds before conducting the next test.

GO TO 2 .

With CONSULT

1. Turn the ignition switch OFF.
   NOTE: Wait at least 10 seconds after turning ignition switch OFF.
2. Start the engine.
   NOTE: Wait at least 10 seconds after starting the engine.
3. Perform "Self Diagnostic Result" of "ABS".

Is DTC "C1170" detected?

YES

"C1170" is displayed as "CRNT": Proceed to Diagnosis Procedure .

YES

"C1170" is displayed as "PAST": Inspection End (Erase "Self Diagnostic Result" of "ABS").

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: Inspection End.