Work Procedure
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
Fully understand the following items well before the road test;
- Precautions: Refer to Blind Spot Warning System Service .
- System description for RCTA: Refer to System Description .
- Normal operating condition: Refer to Description .
- CHECK BSW/RCTA SYSTEM SETTING
- Start the engine.
- Check that the BSW system setting can be enabled/disabled on the integral switch.
- Turn ignition switch OFF and wait for 30 seconds or more.
- Check that the previous setting is saved when the engine starts again.
GO TO 2 .
- ACTION TEST FOR RCTA
- Enable the setting of the RCTA system on the integral switch.
- Check the RCTA operation according to the following table:
Vehicle condition
Action
Buzzer
- R range
- 5 MPH (8 km/h)
If the radar detects an approaching vehicle from the side.
- Chime sounds (single beep)
- Flashes Blind Spot Warning indicator on the side that the approaching vehicle is detected
- Yellow rectangular frame appears in the display.
Single beep
No approaching vehicle
No action
-
Inspection End.