DTC Confirmation Procedure

If DTC P2014, P2016, P2017 or P2018 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643.

Is applicable DTC detected?

YES

Perform diagnosis of applicable. Refer to DTC Description .

NO

GO TO 2.

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

GO TO 3.

1. Start engine and warm it up to the normal operating temperature.
2. Fully release accelerator pedal and wait at least 10 seconds.
3. Rev engine up to more than 5, 000 rpm and wait at least 10 seconds.
4. Check 1st trip DTC.

Is 1st trip DTC detected?

YES

Proceed to Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Inspection .

NO

Confirmation after repair: INSPECTION END