Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2018 >> Kicks S >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0130 To P0420 >> DTC P0365: Exhaust Valve Timing Control Position Sensor >> Component Inspection

Component Inspection

  1. EXHAUST CAMSHAFT POSITION SENSOR-1 
    1. Turn ignition switch OFF.
    2. Loosen the sensor mounting bolt.
    3. Disconnect the exhaust camshaft position sensor harness connector.
    4. Remove the exhaust camshaft position sensor.
    5. Visually check the sensor for chipping.
      G04812293Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    GO TO 2.

    NO

    Replace the exhaust camshaft position sensor. Refer to Exploded View .

  2. EXHAUST CAMSHAFT POSITION SENSOR-2 

    Check resistance between exhaust camshaft position sensor terminals as shown below.

    Exhaust camshaft position sensor

    Resistance

    +

    -

    Terminals

    1

    2

    Except 0 Ω [at 25°C (77°F)]

    3

    2

    3

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace the exhaust camshaft position sensor. Refer to Exploded View .

scientia non olet · About Mike's Workshop Manuals