Component Inspection
- CHECK INTAKE CAMSHAFT POSITION SENSOR-I
- Turn ignition switch OFF.
- Loosen the fixing bolt of the sensor.
- Disconnect intake camshaft position sensor harness connector.
- Remove the sensor. Refer to Exploded View .
- Visually check the sensor for chipping.
Is the inspection result normal?
YES
GO TO 2.
NO
Replace intake camshaft position sensor. Refer to Exploded View .
- CHECK INTAKE CAMSHAFT POSITION SENSOR-II
Check resistance intake camshaft position sensor terminals as follows.
Terminals (Polarity)
Resistance [at 25°C (77°F)]
1 (+) - 2 (-)
Except 0 or ∞Ω
1 (+) - 3 (-)
2 (+) - 3 (-)
Is the inspection result normal?
YES
INSPECTION END
NO
Replace intake camshaft position sensor. Refer to Exploded View .