DTC Confirmation Procedure

INSPECTION START

Do you have CONSULT?

Do you have CONSULT?

YES

GO TO STEP 2 .

NO

GO TO STEP 5 .

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
GO TO STEP 3 .

CHECK VEHICLE SPEED SENSOR FUNCTION

NOTE:
This procedure may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.

With CONSULT
1. Start engine.
2. Read "VHCL SPEED SE" in "DATA MONITOR" mode with CONSULT. The vehicle speed on CONSULT should exceed 10 km/h (6 mph) when rotating wheels with suitable gear position.
Is the inspection result normal?

YES

GO TO STEP 4 .

NO

Go to DIAGNOSIS PROCEDURE .

PERFORM DTC CONFIRMATION PROCEDURE

Select "DATA MONITOR" mode with CONSULT.
Warm engine up to normal operating temperature.

Maintain the following conditions for at least 60 consecutive seconds.

CAUTION:

Always drive vehicle at a safe speed.

ENG SPEED	1, 400 - 6, 000 rpm (CVT) 1, 900 - 6, 000 rpm (M/T)
COOLANT TEMP/S	More than 70°C (158°F)
B/FUEL SCHDL	6.2 - 31.8 msec (CVT) 4.5 - 31.8 msec (M/T)
Shift lever	Except P or N position (CVT) Except Neutral position (M/T)
PW/ST SIGNAL	OFF

Check 1st trip DTC.

Is 1st trip DTC detected?

YES

Go to DIAGNOSIS PROCEDURE .

NO

INSPECTION END

PERFORM COMPONENT FUNCTION CHECK

Perform component function check. Refer to COMPONENT FUNCTION CHECK .

Use component function check to check the overall function of the vehicle speed signal circuit. During this check, a 1st trip DTC might not be confirmed.

Is the inspection result normal?

YES

INSPECTION END

NO

Go to DIAGNOSIS PROCEDURE .