Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2017 >> Versa 1.6 SL >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Unit Disassembly And Assembly >> Steering Gear And Linkage >> Disassembly And Assembly >> Assembly

Disassembly And Assembly: Assembly

  1. Apply Three Bond 1111B or equivalent to inner socket and turn pinion fully to retract inner socket into gear housing assembly.
  2. Install large end (1) of boot (2) to gear housing assembly.
    G05877437Courtesy of NISSAN NORTH AMERICA, INC.
  3. Install small end (3) of boot (2) to inner socket boot mounting groove.
  4. Install boot clamp to boot small end.
    G04134821Courtesy of NISSAN NORTH AMERICA, INC.
  5. Install boot clamp to boot large end using Tool.
    CAUTION:

    Do not reuse boot clamps.

    Tool number : KV40107300 (J-51751)
  6. Adjust inner socket to standard length (L) and then tighten lock nut to the specified torque. Check length of inner socket (L) again after tightening lock nut. Make sure that the length is the standard.
    G04076779Courtesy of NISSAN NORTH AMERICA, INC.
    Inner socket length (L) : Refer to BALL JOINT SWING FORCE .
    CAUTION:

    Adjust toe-in after this procedure. The length achieved after toe-in adjustment is not necessarily the above value.

scientia non olet · About Mike's Workshop Manuals