DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is between 10 V and 16 V at idle. 

GO TO STEP 2  .

With CONSULT

1. Turn ignition switch ON.
2. On CONSULT screen, select "ENGINE">>"Data Monitor".
3. Start engine and warm it up to the normal operating temperature.
4. Maintain the following conditions for at least 10 consecutive seconds. Hold the accelerator pedal as steady as possible.

   ENG SPEED	1, 200 - 2, 000 RPM
   COOLANT TEMP/S	More than 60°C (140°F)
   Selector lever	P or N position

5. Let engine idle for 10 seconds.
6. Check 1st trip DTC.

With GST 

Follow the procedure "With CONSULT" above.

Is DTC P0018 detected?

YES 

Proceed to DIAGNOSIS PROCEDURE .

NO 

GO TO STEP 3  .

With CONSULT

1. Maintain the following conditions for at least 5 consecutive seconds.

   ENG SPEED	1, 200 - 3, 175 RPM (A constant rotation is maintained.)
   COOLANT TEMP/S	More than 64°C (147°F)
   Selector lever	1st or 2nd position
   Driving location	Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)

   CAUTION:

   Always drive at a safe speed.

2. Check 1st trip DTC.

With GST 

Follow the procedure "With CONSULT" above.

Is DTC P0018 detected?

YES 

Proceed to DIAGNOSIS PROCEDURE .

NO-1 

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

NO-2 

Confirmation after repair: INSPECTION END