DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

GO TO STEP 2  .

1. Turn ignition switch OFF.
2. Check engine oil level. Refer to INSPECTION .

Is inspection result normal?

YES 

GO TO STEP 3  .

NO 

Check engine oil leak. Refer to INSPECTION .

1. Start engine and let it idle for at least 5 seconds.
2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES 

Proceed to DIAGNOSIS PROCEDURE .

NO - 1 

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

NO - 2 

Confirmation after repair: INSPECTION END