Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2017 >> Altima Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Steering Control System) >> DTC/Circuit Diagnosis >> DTC C1607, C1608: Power Steering Control Module >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

  1. PRECONDITIONING

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO STEP 2  .

  2. DTC REPRODUCTION PROCEDURE

    G-20CONSULT 

    1. Turn the ignition switch OFF to ON.
    2. Perform "Self Diagnostic Result" mode of "EPS".

    Is DTC "C1607" or "C1608" detected?

    YES 

    Proceed to diagnosis procedure. Refer to DIAGNOSIS PROCEDURE .

    NO 

    Inspection End.

scientia non olet · About Mike's Workshop Manuals