Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2016 >> Versa Note SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Control System (Introduction, Wiring Diagrams And Basic Inspection)) >> Basic Inspection >> Mixture Ratio Self-Learning Value Clear >> Work Procedure >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.

  1. START

    G-20With CONSULT 

    1. Start the engine and warm it up to normal operating temperature.
    2. Select "SELF-LEARNING CONT" in "WORK SUPPORT" mode with CONSULT.
    3. Clear mixture ratio self-learning value by touching "CLEAR".

    NSM020With GST 

    1. Start the engine and warm it up to normal operating temperature.
    2. Turn ignition switch OFF.
    3. Disconnect mass air flow sensor harness connector.
    4. Restart the engine and let it idle for at least 5 seconds.
    5. Stop the engine and reconnect mass air flow sensor harness connector.
    6. Select Service $03 with GST. Make sure DTC P0102 is detected.
    7. Select Service $04 with GST to erase the DTC P0102.

    END

scientia non olet · About Mike's Workshop Manuals