Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK REAR POWER WINDOW MOTOR LH INPUT SIGNAL
   
   
   1. Turn ignition switch OFF.
   2. Disconnect rear power window motor LH connector.
   3. Turn ignition switch ON.
   4. Check voltage between rear power window motor LH harness connector and ground.

   (+)		(-)	Condition		Voltage (V) (Approx.)
   Rear power window motor LH
   Connector	Terminal
   D204	1	Ground	Rear power window switch LH	NEUTRAL	0
   				UP	Battery voltage
   	2			NEUTRAL	0
   				DOWN	Battery voltage

   Is the inspection result normal?

   YES 

   Replace rear power window motor LH.

   NO 

   GO TO STEP 2  .

2. CHECK REAR POWER WINDOW MOTOR LH CIRCUIT
   
   
   1. Turn ignition switch OFF.
   2. Disconnect rear power window switch LH connector.
   3. Check continuity between rear power window switch LH harness connector and rear power window motor LH harness connector.

      Rear power window switch LH		Rear power window motor LH		Continuity
      Connector	Terminal	Connector	Terminal
      D203	6	D204	2	Yes
      	5		1

   4. Check continuity between rear power window switch LH connector and ground.

      Rear power window switch LH		Ground	Continuity
      Connector	Terminal
      D203	6		No
      	5

   Is the inspection result normal?

   YES 

   Replace rear power window switch LH. Refer to REMOVAL AND INSTALLATION .

   NO 

   Repair or replace harness.