Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2016 >> Versa Note S, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Audio, Visual & Navigation System (Navigation)) >> Removal And Installation >> Av Control Unit >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2016 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Remove battery terminal and AV control unit after a lapse of 30 seconds or more after turning the ignition switch OFF.
  • Before replacing AV control unit, perform "READ CONFIGURATION" to save current vehicle specification. Refer to DESCRIPTION .
NOTE:

After the ignition switch is turned OFF, the AV control unit continues operating for approximately 30 seconds. Therefore, data corruption may occur if battery voltage is cut off within 30 seconds.

  1. Disconnect the negative battery terminal. Refer to REMOVAL AND INSTALLATION .
  2. Remove cluster lid C. Refer to REMOVAL AND INSTALLATION .
  3. Remove the AV control unit screws, then pull out the AV control unit.
  4. Disconnect the harness connectors from the AV control unit and remove.
scientia non olet · About Mike's Workshop Manuals