Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2016 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Body Control System (With Intelligent Key System)) >> Removal And Installation >> Combination Switch >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2017 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before servicing, turn the ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
  • Do not use air or electric tools when removing or installing the combination switch.
  1. Disconnect both the negative and positive battery terminals, then wait at least three minutes. Refer to REMOVAL AND INSTALLATION (BATTERY) .
  2. Remove the steering column covers. Refer to REMOVAL AND INSTALLATION .
  3. Rotate steering wheel clockwise to access first combination switch bolt and remove.
  4. Rotate steering wheel counter-clockwise to access second combination switch bolt and remove.
  5. Disconnect the harness connector from the combination switch and remove.
scientia non olet · About Mike's Workshop Manuals