Diagnosis Procedure
WARNING: This page is about a different car, the 2015 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
Regarding Wiring Diagram information, refer to WIRING DIAGRAM .
- CHECK FUSES
Check that the following fuse is not blown:
Signal name Fuse No. Ignition power supply 29 (10A) Is the fuse blown?
YES
Replace the blown fuse after repairing the affected circuit.
NO
GO TO STEP 2 .
- CHECK ADAS CONTROL UNIT POWER SUPPLY CIRCUIT
Check voltage between ADAS control unit harness connector and ground.
Terminal Condition Voltage
(Approx.)(+) (-) ADAS control unit Ground Ignition switch Connector Terminal M182 3 OFF 0 V ON Battery voltage Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair the ADAS control unit power supply circuit.
- CHECK ADAS CONTROL UNIT GROUND CIRCUIT
- Turn the ignition switch OFF.
- Disconnect the ADAS control unit connector.
- Check for continuity between ADAS control unit harness connector and ground.
ADAS control unit Ground Continuity Connector Terminal M182 1 Yes
Is the inspection result normal?
YES
Inspection End.
NO
Repair the ADAS control unit ground circuit.