Common Specs & Procedures
ALTIMA COMMON SPECS & PROCEDURES
| System | Specification/Procedure | |||
|---|---|---|---|---|
| Air Conditioning | ||||
| Service | SERVICE DATA AND SPECIFICATIONS (SDS) | |||
| Torque | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION | |||
| Axle Nut/Hub Bearing Bolts | ||||
| Front Axle Nut | 135 Ft. lbs (182.5 N.m) | |||
| Front Hub Bearing Bolts | 65 Ft. lbs (88.3 N.m) | |||
| Rear Hub Bearing Bolts | 65 Ft. lbs (88.3 N.m) | |||
| Battery | SERVICE DATA AND SPECIFICATIONS (SDS) | |||
| Brakes | ||||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | |||
| Disc Brakes | ||||
| Front | FRONT DISC BRAKE | |||
| Rear | REAR DISC BRAKE | |||
| Torque | ||||
| Front | See Torque Specifications in text and applicable figures under FRONT DISC BRAKE | |||
| Rear | See Torque Specifications in text and applicable figures under REAR DISC BRAKE | |||
| Charging | ||||
| Generator | SERVICE DATA AND SPECIFICATIONS (SDS) | |||
| Torque | See Torque Specifications in text and applicable figures under QR25DE or VQ35DE . | |||
| Drive Belts | ||||
| Adjustment | Vehicle equipped with auto-tensioner | |||
| Belt Routing | ||||
| QR25DE | DRIVE BELTS | |||
| VQ35DE | DRIVE BELTS | |||
| Engine Cooling | ||||
| General Service Specifications | ||||
| QR25DE | SERVICE DATA AND SPECIFICATIONS (SDS) | |||
| VQ35DE | SERVICE DATA AND SPECIFICATIONS (SDS) | |||
| Radiator Cap Pressure | ||||
| QR25DE & VQ35DE | 17-20 psi (117-137 kPa, 1.2-1.4 kgf/cm2 ) | |||
| Thermostat R & I | ||||
| QR25DE | THERMOSTAT AND THERMOSTAT HOUSING | |||
| VQ35DE | THERMOSTAT AND THERMOSTAT HOUSING | |||
| Water Pump R & I | ||||
| QR25DE | WATER PUMP | |||
| VQ35DE | WATER PUMP | |||
| Engine Mechanical | ||||
| Compression | ||||
| QR25DE | COMPRESSION PRESSURE | |||
| VQ35DE | COMPRESSION PRESSURE | |||
| Oil Pressure | ||||
| @ Idle | 14 psi (98 kPa, 1.0 kg/cm2 ) | |||
| @ 2000 RPM | 43 psi (294 kPa, 3.0 kg/cm2 ) | |||
| @ 6000 RPM | 57 psi (392 kPa, 4.0 kg/cm2 ) | |||
| Overhaul | ||||
| QR25DE | SERVICE DATA AND SPECIFICATIONS (SDS) | |||
| VQ35DE | SERVICE DATA AND SPECIFICATIONS (SDS) | |||
| Torque | ||||
| QR25DE | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | |||
| VQ35DE | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | |||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |||
| Flywheel/Flex Plate (Drive Plate) Torque | ||||
| QR25DE | 80 Ft. lbs (108 N.m) | |||
| VQ35DE | 65 Ft. lbs (88 N.m) | |||
| Fuel System | ||||
| Fuel Pressure Release Procedure | ||||
| QR25DE | FUEL PRESSURE RELEASE | |||
| VQ35DE | FUEL PRESSURE RELEASE | |||
| Fuel Pressure Specification | At Idling: Approximately 51 psi (350 kPa, 3.57 kg/cm2 ) | |||
| Fuel Pressure Test Procedure | ||||
| QR25DE | FUEL PRESSURE CHECK | |||
| VQ35DE | FUEL PRESSURE CHECK | |||
| Fuel Filter Location | In Tank Type | |||
| Fuel Filter R & I | FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY | |||
| Ignition | ||||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |||
| Ignition Wires (Resistance) | Coil On Plug | |||
| Ignition Wires (Routing) | Engine has coil-on-plug ignition. | |||
| Spark Plugs | ||||
| QR25DE | DENSO - FXE20HE11C Tightening torque: 14 Ft. Lbs (19.6 N.m) Gap (nominal) - 1.1 mm (0.043 in) |
|||
| VQ35DE | DENSO - FXE22HR11 Tightening torque: 14 Ft. Lbs (19.6 N.m) Gap (nominal) - 1.1 mm (0.043 in) |
|||
| Starting | ||||
| Starter | SERVICE DATA AND SPECIFICATIONS (SDS) | |||
| Torque | ||||
| QR25DE | See Torque Specifications in text and applicable figures under QR25DE | |||
| VQ35DE | See Torque Specifications in text and applicable figures under VQ35DE | |||
| Wheel Alignment | ||||
| Adjustment Specifications | ||||
| Front | WHEEL ALIGNMENT (UNLADEN * 1) | |||
| Rear | WHEEL ALIGNMENT (UNLADEN *) | |||
| Torque | ||||
| Front | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | |||
| Rear | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | |||
| Wheel Lug Nut Torque | 83 Ft. lbs (113 N.m) | |||
| How To Use Nissan Service Information | ||||
| Includes: Standard Bolt Torque Symbol Identification General Connector Info |
GENERAL INFORMATION | |||