Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK PUSH-BUTTON IGNITION SWITCH SIGNAL (PUSH-BUTTON IGNITION SWITCH)
   
   

   Check voltage between push-button ignition switch connector M25 and ground.

   Push-button ignition switch		Ground	Voltage (Approx.)
   Connector	Terminal
   M25	8	-	Battery voltage

   Is the inspection result normal?

   YES 

   GO TO STEP 2  .

   NO 

   GO TO STEP 3  .

2. CHECK PUSH-BUTTON IGNITION SWITCH SIGNAL (IPDM E/R)
   
   

   Check voltage between IPDM E/R connector E39 and ground.

   IPDM E/R		Ground	Voltage (Approx.)
   Connector	Terminal
   E39	66	-	Battery voltage

   Is the inspection result normal?

   YES 

   Replace IPDM E/R. Refer to REMOVAL AND INSTALLATION .

   NO 

   Repair or replace harness or connectors.

3. CHECK PUSH-BUTTON IGNITION SWITCH SIGNAL CIRCUIT (PUSH-BUTTON IGNITION SWITCH)
   
   
   1. Disconnect push-button ignition switch connector, IPDM E/R connector E39 and BCM connector M83.
   2. Check continuity between BCM connector M83 and push-button ignition switch connector M25.

      BCM		Push-button ignition switch		Continuity
      Connector	Terminal	Connector	Terminal
      M83	55	M25	8	Yes

   3. Check continuity between BCM connector M83 and ground.

      BCM		Ground	Continuity
      Connector	Terminal
      M83	55	-	No

   Is the inspection result normal?

   YES 

   Replace BCM. Refer to REMOVAL AND INSTALLATION .

   NO 

   Repair or replace harness or connectors.