Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect front power window motor (driver side) connector.
3. Turn ignition switch ON.
4. Check voltage between power window motor (driver side) harness connector and ground.

   (+)		(-)	Condition		Voltage (V) (Approx.)
   Power window motor (driver side)
   Connector	Terminal
   D7	1	Ground	Power window main switch	UP	Battery voltage
   				DOWN	0
   	2			UP	0
   				DOWN	Battery voltage

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

GO TO STEP 2  .

1. Turn ignition switch OFF.
2. Disconnect power window main switch connector.
3. Check continuity between power window main switch harness connector and front power window motor (driver side) harness connector.

   Power window main switch		Front power window motor (driver side)		Continuity
   Connector	Terminal	Connector	Terminal
   D5	8	D7	2	Existed
   	11		1

4. Check continuity between power window main switch harness connector and ground.

   Power window main switch		Ground	Continuity
   Connector	Terminal
   D5	8		Not existed
   	11

Is the inspection result normal?

YES 

Replace power window main switch.Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.

Check front power window motor (driver side).

Refer to COMPONENT INSPECTION .

Is the inspection result normal?

YES 

GO TO STEP 4  .

NO 

Replace power window motor (driver side). Refer to DISASSEMBLY AND ASSEMBLY .

Refer to INTERMITTENT INCIDENT .

INSPECTION END