Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2015 >> Rogue S, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Driver Assistance System (Driver Assistance System) >> DTC/Circuit Diagnosis >> Power Supply And Ground Circuit >> Around View Monitor Control Unit >> Diagnosis Procedure >> With Driver Assistance System

With Driver Assistance System

  1. CHECK FUSE

    Check that the following fuses are not blown:

    Terminal No. Signal name Fuse No.
    2 Battery power supply 15 (20A)

    Are the fuses blown?

    YES 

    Replace the blown fuse after repairing the affected circuit.

    NO 

    GO TO STEP 2  .

  2. CHECK POWER SUPPLY CIRCUIT

    1. Turn ignition switch OFF.
    2. Disconnect around view monitor control unit connector M113.
    3. Check voltage between around view monitor control unit connector M113 and ground.
      Around view monitor control unit Ground Condition Voltage
      (Approx.)
      Connector Terminal
      M113 2 - Ignition switch: OFF Battery voltage

    Is the inspection result normal?

    YES 

    GO TO STEP 3  .

    NO 

    Repair or replace harness or connectors.

  3. CHECK GROUND CIRCUIT

    1. Turn ignition switch OFF.
    2. Check continuity between around view monitor control unit connector M113 and ground.
      Around view monitor control unit Ground Continuity
      Connector Terminal
      M113 1 - Yes

    Is the inspection result normal?

    YES 

    Inspection End.

    NO 

    Repair or replace harness or connectors.

scientia non olet · About Mike's Workshop Manuals