Inspection Procedure

WARNING:

Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION:

Fully understand the following items well before the road test;
- Precautions: Refer to PRECAUTIONS FOR DRIVER ASSISTANCE SYSTEMS .
- System description for LDW: Refer to SYSTEM DESCRIPTION .
- System description for BSW: Refer to SYSTEM DESCRIPTION .
- System description for MOD: Refer to SYSTEM DESCRIPTION .
- System description for FCW: Refer to SYSTEM DESCRIPTION .
- Handling precaution: Refer to PRECAUTIONS FOR FORWARD COLLISION WARNING .

CHECK FCW SYSTEM SETTING
1. Start the engine.
2. Check that the FCW system setting can be enabled/disabled on the vehicle information display.
3. Turn OFF the ignition switch and wait for 30 seconds or more.
4. Check that the previous setting is saved when the engine starts again.
GO TO STEP 2 .

ACTION TEST FOR FCW

Enable the setting of the FCW system on the vehicle information display.
Turn warning systems switch ON (warning systems ON indicator is ON).

Check the FCW operation according to the following table:

Vehicle condition/ Driver's operation		Action	Warning systems ON indicator	Indication on the combination meter	Buzzer
Less than Approx. 10 MPH (15 km/h)	-	No action	ON	FCW indicator (white) ON steady Courtesy of NISSAN NORTH AMERICA, INC.	-
Approx. 10 MPH (15 km/h or more	Vehicle is not detected	No action	ON	FCW indicator (white) ON steady Courtesy of NISSAN NORTH AMERICA, INC.	OFF
Approx. 10 MPH (15 km/h or more	Vehicle is detected	Warning buzzer sounds Warning lamp blinks	ON	FCW indicator (white) ON blinks Courtesy of NISSAN NORTH AMERICA, INC.	Short continuous beeps

NOTE:

If the vehicle speed exceeds approximately 10 MPH (15 km/h), FCW function operates until the vehicle speed becomes lower than approximately 10 MPH (15 km/h).

Inspection End.