Inspection Procedure

WARNING:

Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION:

Fully understand the following items well before the road test;
- Precautions: Refer to PRECAUTIONS FOR DRIVER ASSISTANCE SYSTEMS .
- System description for LDW: Refer to SYSTEM DESCRIPTION .
- System description for BSW: Refer to SYSTEM DESCRIPTION .
- System description for MOD: Refer to SYSTEM DESCRIPTION .
- Handling precaution: Refer to PRECAUTIONS FOR BLIND SPOT WARNING .

CHECK BSW SYSTEM SETTING
1. Start the engine.
2. Check that the BSW system setting can be enabled/disabled on the vehicle information display.
3. Turn OFF the ignition switch and wait for 30 seconds or more.
4. Check that the previous setting is saved when the engine starts again.
GO TO STEP 2 .

ACTION TEST FOR BSW

Enable the setting of the BSW system on the vehicle information display.
Turn warning systems switch ON (warning systems ON indicator is ON).

Check the BSW operation according to the following table.

VEHICLE CONDITION/DRIVER'S OPERATION

Warning systems ON indicator	Vehicle speed (Approx.) [km/h (MPH)]	Turn signal condition	Status of vehicle detection within detection area	Indication on the combination meter	Buzzer
ON	Less than Approx. 29 km/h (18 MPH)	-	-	OFF	OFF
	Approx. 32 km/h (20 MPH) or more	-	Vehicle is absent	OFF	OFF
		OFF	Vehicle is detected	ON	OFF
		ON (vehicle detected direction)	Before turn signal operates vehicle is detected	Blink Courtesy of NISSAN NORTH AMERICA, INC.	Short continuous beeps Courtesy of NISSAN NORTH AMERICA, INC.
		ON (vehicle detected direction)	Vehicle is detected after turn signal operates	Blink Courtesy of NISSAN NORTH AMERICA, INC.	OFF

NOTE:

After the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches approximately 60 km/h (40 MPH). Refer to SYSTEM DESCRIPTION .

Inspection End.