DTC Confirmation Procedure

1. Press push-button ignition switch under the following conditions to start engine, and wait 5 seconds or more.

   CVT models

   • Selector lever: In the P position
   • Brake pedal: Depressed

   M/T models

   • Shift lever: In the Neutral position
   • Clutch pedal: Depressed
2. Check DTC in "Self Diagnostic Result" mode of "IPDM E/R" using CONSULT.

Is DTC detected?

YES 

Go to DIAGNOSIS PROCEDURE .

NO (M/T models) 

INSPECTION END

NO (CVT models) 

GO TO STEP 2  .

1. Stop engine.
2. Perform DTC CONFIRMATION PROCEDURE for DTC P1650. Refer to DTC LOGIC .
3. Turn ignition switch ON.
4. Check DTC in "Self Diagnostic Result" mode of "IPDM E/R" using CONSULT.

Is DTC detected?

YES 

Refer to DIAGNOSIS PROCEDURE .

NO 

INSPECTION END