Component Inspection

1. Reconnect all harness connectors disconnected.
2. Turn ignition switch ON.
3. Check the voltage between ECM harness connector and ground.

   ECM			Condition		Voltage
   Connector	Terminal
   	+	-
   E16	110 (APP sensor 1 signal)	111	Accelerator pedal	Fully released	0.6 - 0.9 V
   				Fully depressed	3.9 - 4.7 V
   	103 (APP sensor 2 signal)	104		Fully released	0.3 - 0.6 V
   				Fully depressed	1.95 - 2.4 V

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: GO TO 2.

Replace accelerator pedal assembly. Refer to "EXPLODED VIEW ".

: INSPECTION END