Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2014 >> Versa Note S Plus >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Diagnostic Codes & Symptom Tests) >> DTC/Circuit Diagnosis >> DTC P2135: TP Sensor >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK GROUND CONNECTION 
    1. Turn ignition switch OFF.
    2. Check ground connection E15. Refer to Ground Inspection in "CIRCUIT INSPECTION ".

      Is the inspection result normal? 

      YES: GO TO 2.

      NO: Repair or replace ground connection.

  2. CHECK THROTTLE POSITION SENSOR POWER SUPPLY CIRCUIT 
    1. Disconnect electric throttle control actuator harness connector.
    2. Turn ignition switch ON.
    3. Check the voltage between electric throttle control actuator harness connector and ground.
      Electric throttle control actuator Ground Voltage
      Connector Terminal
      F7 2 Ground Approx. 5 V

      Is the inspection result normal? 

      YES: GO TO 3.

      NO: Repair open circuit or short to ground or short to power in harness or connectors.

  3. CHECK THROTTLE POSITION SENSOR GROUND CIRCUIT FOR OPEN AND SHORT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the continuity between electric throttle control actuator harness connector and ground.
      Electric throttle control actuator ECM Continuity
      Connector Terminal Connector Terminal
      F7 4 F11 36 Existed
    4. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: GO TO 4.

      NO: Repair open circuit or short to ground or short to power in harness or connectors.

  4. CHECK THROTTLE POSITION SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 
    1. Check the continuity between electric throttle control actuator harness connector and ground.
      Electric throttle control actuator ECM Continuity
      Connector Terminal Connector Terminal
      F7 1 F11 33 Existed
      3 34
    2. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: GO TO 5.

      NO: Repair open circuit or short to ground or short to power in harness or connectors.

  5. CHECK THROTTLE POSITION SENSOR 

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: GO TO  7.

    NO: GO TO 6.

  6. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR 

    Replace electric throttle control actuator. Refer to "REMOVAL AND INSTALLATION ".

    : INSPECTION END

  7. CHECK INTERMITTENT INCIDENT 

    Refer to "INTERMITTENT INCIDENT ".

    : INSPECTION END

scientia non olet · About Mike's Workshop Manuals