Component Inspection

CHECK ACCELERATOR PEDAL POSITION SENSOR

Reconnect all harness connectors disconnected.
Turn ignition switch ON.
Check the voltage between ECM harness connector and ground.

ECM			Condition		Voltage
Connector	Terminal
Connector	+	-
E16	110 (APP sensor 1 signal)	111	Accelerator pedal	Fully released	0.6 - 0.9 V
	110 (APP sensor 1 signal)	111		Fully depressed	3.9 - 4.7 V
	103 (APP sensor 2 signal)	104		Fully released	0.3 - 0.6 V
	103 (APP sensor 2 signal)	104		Fully depressed	1.95 - 2.4 V

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

REPLACE ACCELERATOR PEDAL ASSEMBLY
Replace accelerator pedal assembly. Refer to "EXPLODED VIEW ".

: INSPECTION END