Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2014 >> Versa Note S Plus >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Diagnostic Codes & Symptom Tests) >> DTC/Circuit Diagnosis >> DTC P1550: Battery Current Sensor >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    TESTING CONDITION: 

    Before performing the following procedure, confirm that battery voltage is more than 8V at idle. 

    : GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start engine and wait at least 10 seconds.
    2. Check 1st trip DTC.

      Is 1st trip DTC detected? 

      YES: Go to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals