Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2014 >> Versa Note S Plus >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Diagnostic Codes & Symptom Tests) >> DTC/Circuit Diagnosis >> DTC P059F: Active Grille Shutter >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING 

    If another DTC Confirmation Procedure is conducted just before this procedure, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is between 11V and 16V with ignition switch ON.

    With CONSULT: GO TO 2.

    Without CONSULT: GO TO  5.

  2. DTC CONFIRMATION PROCEDURE B 

    With CONSULT

    1. Start the engine and let it idle for 5 seconds or more.
    2. Check 1st trip DTC.

      Is 1st trip DTC detected? 

      YES: Proceed to "DIAGNOSIS PROCEDURE ".

      NO: GO TO 3.

  3. DTC CONFIRMATION PROCEDURE A AND D 

    With CONSULT

    1. Turn ignition switch OFF and wait 10 seconds or more.
    2. Turn ignition switch ON.
    3. Select "DATA MONITOR" mode of "ENGINE" using CONSULT.
    4. Start the engine if the following conditions are met.
      INT/A TEMP SE 0°C (32°F) or more
      COOLANT TEMP/S 0°C (32°F) or more
    5. Select "ACTIVE GRILLE SHUTTER" in "ACTIVE TEST" of "ENGINE" using CONSULT.
    6. Touch "CALIBRTN" at least 60 seconds.
    7. Check 1st trip DTC.

      Is 1st trip DTC is detected? 

      YES: Proceed to "DIAGNOSIS PROCEDURE ".

      NO: GO TO 4.

  4. DTC CONFIRMATION PROCEDURE C 

    With CONSULT

    1. Drive 10 minutes or more under the status that following conditions are met.
      VHCL SPEED SE 40 km/h (25 MPH) or more
      INT/A TEMP SE 50°C (122°F) or less
      CAUTION: Always drive at a safe speed.
      NOTE: Maintain the conditions for 10 minutes or more for accumulation.
    2. Check 1st trip DTC.

      Is 1st trip DTC detected? 

      YES: Proceed to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

  5. DTC CONFIRMATION PROCEDURE A, B AND D 
    1. Start the engine when the following conditions are met.
      Intake air temperature 0°C (32°F) or more
      Engine coolant temperature 0°C (32°F) or more
    2. Drive the vehicle at 10 km/h (7 MPH) or more for at least 60 seconds.
    3. Check DTC.

      Is 1st trip DTC detected? 

      YES: Proceed to "DIAGNOSIS PROCEDURE ".

      NO: GO TO 6.

  6. DTC CONFIRMATION PROCEDURE C 
    1. Drive the vehicle for 10 minutes or more with the following conditions.
      Vehicle speed 40 km/h (25 MPH) or more
      Intake air temperature 50°C (122°F) or less
      CAUTION: Always drive at a safe speed.
      NOTE: Maintain the conditions for 10 minutes or more for accumulation.
    2. Check DTC.

      Is 1st trip DTC detected? 

      YES: Proceed to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals