ADDITIONAL SERVICE WHEN REPLACING AROUND VIEW MONITOR CONTROL UNIT: Work Procedure

SAVING VEHICLE SPECIFICATION
-CONSULT

Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.

NOTE: If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing around view monitor control unit.

: GO TO 2.
REPLACE AROUND VIEW MONITOR CONTROL UNIT
Replace around view monitor control unit. Refer to "REMOVAL AND INSTALLATION ".

: GO TO 3.
WRITING VEHICLE SPECIFICATION
CONSULT
1. Enter "Re/Programming, Configuration".
2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to "CONFIGURATION (AROUND VIEW MONITOR CONTROL UNIT): WORK PROCEDURE ".
3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to "CONFIGURATION (AROUND VIEW MONITOR CONTROL UNIT): WORK PROCEDURE ".
  : GO TO 4.
OPERATION CHECK
Check that the operation of the around view monitor control unit and camera images (fixed guide lines and predictive course lines) are normal.

: Work End.