Required Tools

WARNING: This page is about a different car, the 2016 Nissan Rogue. However, it is still accessible from the selected car via links, so may be relevant.

Distance sensor alignment kit 1-20-2851-1 in addition to one of the following:
a) Hunter self-centering wheel adapter (Hunter wheel alignment tool)

b) Special Service Tool kit 1-20-2722-1 (kit SCA W/Tire Clamp-ICC Aiming)

The following Distance sensor alignment kit (1-20-2851-1) is necessary to perform the Distance sensor alignment:

Distance sensor target board (1).

Fig 1: Distance Sensor Target Board
Courtesy of NISSAN NORTH AMERICA, INC.
Hunter self-centering wheel adapter (1) [shown with laser assembly (2) installed] (Hunter alignment rack head may be substituted).

Fig 2: Self-Centering Wheel Adapter And Laser Assembly
Courtesy of NISSAN NORTH AMERICA, INC.

NOTE:
Dealers that are not equipped with a Hunter self-centering wheel adapter will require the following kit:

Part No. 1-20-2722-1-IF (kit SCA W/Tire Clamp-Distance Sensor Aiming)
Laser assembly (with bi-directional laser beam) as shown in the illustration.

Fig 3: Laser Assembly Related Components
Courtesy of NISSAN NORTH AMERICA, INC.
1. Tightening knob (1)
2. Power ON/OFF button (2)
3. Front laser beam opening (3)
4. Rear laser beam opening (4)
5. Attaching shaft (5)
Stationary target as shown in the illustration.

Fig 4: Stationary Target And Laser Signal Reception Plate
Courtesy of NISSAN NORTH AMERICA, INC.
1. Stationary target (1)
2. Laser signal reception plate (2)
Distance chain (not shown).