Diagnostic Test

WARNING: This page is about a different car, the 2016 Nissan Rogue. However, it is still accessible from the selected car via links, so may be relevant.

SAVING VEHICLE SPECIFICATION (BCM)

CONSULT

Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.

NOTE:
If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing BCM.

GO TO STEP 2 .

SAVING VEHICLE SPECIFICATION (CAN GATEWAY)

CONSULT

Perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to CONSULT FUNCTION .

NOTE:
If "READ CONFIGURATION" cannot be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.

GO TO STEP 3 .

REPLACE BCM

Replace BCM. Refer to REMOVAL AND INSTALLATION .

GO TO STEP 4 .

WRITING VEHICLE SPECIFICATION (BCM)

CONSULT
1. Enter "Re/Programming, Configuration".
2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to WORK PROCEDURE .
3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to WORK PROCEDURE .
GO TO STEP 5 .

REGISTER INTELLIGENT KEYS

For initialization and registration of Intelligent Keys, refer to CONSULT Immobilizer mode and follow the on-screen instructions.

GO TO 5.

INITIALIZE BCM (NATS)

Perform BCM initialization. (NATS)

GO TO STEP 6 .

INITIALIZE TPMS

Perform TPMS initialization. Refer to WORK PROCEDURE .

GO TO STEP 7 .

WRITING VEHICLE SPECIFICATION (CAN GATEWAY FUNCTION)

CONSULT

Perform "WRITE CONFIGURATION - Config file" or "WRITE CONFIGURATION - Manual selection" to write vehicle specification. Refer to WORK PROCEDURE .

Work End.