Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2014 >> Rogue SL, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Driver Assistance System (Chassis Control) (DTCS)) >> DTC Diagnosis >> DTC C1B95-00: Control Module >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Nissan Rogue. However, it is still accessible from the selected car via links, so may be relevant.

  1. PRECONDITIONING

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO STEP 2  .

  2. CHECK DTC DETECTION

    G-20 With CONSULT

    1. Turn the ignition switch OFF to ON.
      CAUTION:

      Be sure to wait of 10 seconds after turning ignition switch OFF or ON.

    2. Perform "Self Diagnostic Result" of "CHASSIS CONTROL".

    Is DTC "C1B95-00" detected?

    YES 

    Proceed to DIAGNOSIS PROCEDURE .

    NO-1 

    To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

    NO-2 

    Confirmation after repair: Inspection End.

scientia non olet · About Mike's Workshop Manuals