Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect rear power window switch connector.
3. Turn ignition switch ON.
4. Check voltage between rear power window switch harness connector and ground.

   (+)		(-)	Condition		Voltage (Approx.)
   Rear power window switch
   Connector	Terminal
   LH: D204	2	Ground	Power window main switch: LH	UP	Battery voltage
   				DOWN	0
   	3			UP	0
   				DOWN	Battery voltage
   RH: D304	2		Power window main switch: RH	UP	Battery voltage
   				DOWN	0
   	3			UP	0
   				DOWN	Battery voltage

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: GO TO  3.

Check rear power window switch.

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO  4.

NO: Replace rear power window switch. Refer to "REMOVAL AND INSTALLATION ".

1. Turn ignition switch OFF.
2. Disconnect main power window and door lock/unlock switch connector.
3. Check continuity between main power window and door lock/unlock switch harness connector and rear power window switch harness connector.

   Main power window and door lock/unlock switch		Rear power window switch			Continuity
   Connector	Terminal	Connector		Terminal
   D6	9	LH	D204	2	Yes
   	8			3
   	6	RH	D304	3
   	7			2

4. Check continuity between main power and door lock/unlock switch harness connector and ground.

   Main power window and door lock/unlock switch		Ground	Continuity
   Connector	Terminal
   D6	9		No
   	8
   	6
   	7

   Is the inspection result normal? 

   YES: Replace main power window and door lock/unlock switch. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace harness.

Refer to "INTERMITTENT INCIDENT ".

: Inspection End.