DRIVER SIDE: Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect front power window motor LH connector.
3. Turn ignition switch ON.
4. Check voltage between power window motor LH harness connector and ground.

   (+)		(-)	Condition		Voltage (Approx.)
   Power window motor LH
   Connector	Terminal
   D10	3	Ground	Main power window and door lock/unlock switch	UP	Battery voltage
   				DOWN	0
   	1			UP	0
   				DOWN	Battery voltage

   Is the inspection result normal? 

   YES: GO TO  3.

   NO: GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect main power window and door lock/unlock switch connector.
3. Check continuity between main power window and door lock/unlock switch harness connector and front power window motor LH harness connector.

   Main power window and door lock/unlock switch		Front power window motor LH		Continuity
   Connector	Terminal	Connector	Terminal
   D8	17	D10	3	Yes
   	19		1

4. Check continuity between main power window and door lock/unlock switch harness connector and ground.

   Main power window and door lock/unlock switch		Ground	Continuity
   Connector	Terminal
   D8	17		No
   	19

   Is the inspection result normal? 

   YES: Replace main power window and door lock/unlock switch. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace harness.

Check front power window motor LH.

Refer to "DRIVER SIDE: COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 4.

NO: Replace front power window motor LH. Refer to "REMOVAL AND INSTALLATION ".

Refer to "INTERMITTENT INCIDENT ".

: Inspection End.