BSW System Operation Description
- Control unit enables BSW system.
- The control unit turns on the BSW system when the warning systems switch is turned ON.
- Rear view camera detects a vehicle in the adjacent lane, and transmits the vehicle detection signal to control unit.
- Control unit starts the control as follows, based on a vehicle detection signal and turn signal transmitted from BCM via CAN communication:
- Buzzer signal transmission to warning buzzer.
- Around view monitor transmits a blind spot warning indicator signal LH or RH to the blind spot warning indicator LH or RH.
Operation Condition of BSW System
control unit performs the control when the following conditions are satisfied:
- When the warning system switch is turned ON*.
- When the vehicle drives at 20 MPH (32 km/h) or more in the forward direction.NOTE: *: When the BSW system setting on the vehicle information display screen is ON.
- After the operating conditions of warning are satisfied, the warning continues until the vehicle speed is reduced below approximately 18 MPH (29 km/h)
- The BSW system may not function properly, depending on the situation.