MOD: Inspection Procedure

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION:

Fully understand the following items well before the road test;
- Precautions: Refer to "PRECAUTIONS FOR DRIVER ASSISTANCE SYSTEMS ".
- System description for LDW: Refer to "LDW: SYSTEM DESCRIPTION ".
- System description for BSW: Refer to "BSW: SYSTEM DESCRIPTION ".
- System description for MOD: Refer to "MOD: SYSTEM DESCRIPTION ".
- Handling precaution: Refer to "PRECAUTIONS FOR MOVING OBJECTS DETECTION ".

CHECK MOD SYSTEM SETTING
1. Start the engine.
2. Check that the MOD system setting can be enabled/disabled on the vehicle information display.
3. Turn OFF the ignition switch and wait for 30 seconds or more.
4. Check that the previous setting is saved when the engine starts again.
  : GO TO 2.
ACTION TEST FOR MOD

Enable the setting of the MOD system on the vehicle information display.
Turn warning systems switch ON (warning systems ON indicator is ON).

Check the MOD operation according to the following table.

Vehicle condition/Driver's operation			Vehicle response
Moving Object Detection ON indicator	Vehicle speed (Approx.) [km/h (MPH)]	Status of vehicle detection within detection area	Indication on the Moving Object Detection indicator	Buzzer
OFF	-	-	OFF	OFF
Blue	Less than approx. 8 km/h (5 MPH)	Vehicle is detected	ON	ON
	Approx. 8 km/h (5 MPH) or more	Vehicle is absent	ON	OFF
		Vehicle is detected	ON	OFF
		Vehicle is not detected	ON	OFF

NOTE: After the operating conditions of warning are satisfied, the warning continues until the vehicle reaches a higher speed. Refer to "MOD: SYSTEM DESCRIPTION ".

: Inspection End.