Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2014 >> NV200 S >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Diagnostic Codes & Symptom Tests) >> DTC/Circuit Diagnosis >> DTC P0340: CMP Sensor (Phase) >> DTC Logic >> DTC Detection Logic

DTC Detection Logic

NOTE: If DTC P0340 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to "DTC LOGIC ".
DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause
P0340 CMP SEN/CIRC-B1
(Camshaft position sensor "A" circuit bank 1)
  • The cylinder No. signal is not sent to ECM for the first few seconds during engine cranking.
  • The cylinder No. signal is not sent to ECM during engine running.
  • The cylinder No. signal is not in the normal pattern during engine running.
  • Harness or connectors (Camshaft position sensor circuit is open or shorted)
  • Camshaft position sensor
  • Camshaft (Intake)
  • Starter motor
  • Starting system circuit
  • Dead (Weak) battery
  • Sensor power supply 2 circuit
scientia non olet · About Mike's Workshop Manuals