Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2014 >> Leaf SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (EV Control System (Introduction)) >> System Description >> Diagnosis System (VCM) >> CONSULT Function >> Work Support Mode

Work Support Mode

WARNING: This page is about a different car, the 2013 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.
WORK ITEM

WORK ITEM CONDITION USAGE
SAVE DATA FOR CPU REPLACE In this mode, the data saved in VCM is stored in CONSULT. When VCM is replaced.
WRITE DATA AFTER REPLACE CPU In this mode, write data stored by "SAVE DATA FOR CPU REPLACE" in work support mode to VCM. When VCM is replaced.
BATTERY GRADUAL CAP LOSS DATA CLEAR Li-ion Battery deterioration data stored in VCM is cleared. Always perform after Li-ion Battery controller is replaced as new one.
HV BATT J/B DATA CLEAR System Main Relay cutoff count stored in VCM is cleared. Always perform after Li-ion Battery Junction Box is replaced as new one.
WRITE VIN DATA VIN is registered in VCM. When registering VIN in VCM.
SPECIFIC DTC CLEAR(1) Self-diagnosis results of DTC P0AA1 and Freeze Frame Data are cleared. When DTC P0AA1 is detected.
(1) When this is performed, all self-diagnosis results in VCM and Freeze Frame Data are cleared.
scientia non olet · About Mike's Workshop Manuals