Precaution for Harness Repair

WARNING: This page is about a different car, the 2013 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.

Solder the repair part, and wrap it with tape. [Twisted wire fray must be 110 mm (4.33 in) or less.]

Fig 1: Identifying Properly Soldered And Taped Repaired Area
Courtesy of NISSAN NORTH AMERICA, INC.
Never bypass the repair point with wire. (If it is bypassed, the turnout point cannot be separated and the twisted wire characteristics are lost.)

Fig 2: Caution For Bypass Connection

Courtesy of NISSAN NORTH AMERICA, INC.