Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2014 >> Juke SL, FWD, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P1217 To P2263 >> DTC P159B: G Sensor >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

      TEST CONDITION: 

      Before performing the following procedure, confirm that battery voltage is more than 11 V at idle. 

      : GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start engine.
    2. Drive the vehicle for at least 5 seconds at 35 km/h (22 MPH) or more.
    3. Stop the vehicle and let it idle for at least 5 seconds.
      NOTE:
      • Depress the brake pedal to bring the vehicle to a full stop.
      • Never depress the accelerator pedal while the vehicle is stopped.
    4. Repeat Step  2 and Step  3 thirteen times.
    5. Check 1st trip DTC.

      Is 1st trip DTC detected? 

      YES: Proceed to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals