Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2014 >> Juke SL, FWD, Automatic CVT Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P1217 To P2263 >> DTC P1652: Starter Motor System Comm >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

      : GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION 
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Start the engine and wait at least 5 minutes.
    3. Repeat step  1 and  2 for 20 times.
    4. Check DTC.

      Is DTC detected? 

      YES: Proceed to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals