Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2014 >> Juke SL, FWD, Automatic CVT Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P1217 To P2263 >> DTC P158A: ECM >> DTC Logic

DTC Logic

DTC No. Trouble diagnosis name
(Trouble diagnosis content)		 DTC detecting condition Possible cause(1)
P158A G SENSOR
(G sensor calibration is incomplete)		 ECM detects a state that calibration of the G sensor is incomplete. G sensor calibration is incomplete
(1) Since this DTC is detected when G sensor calibration is incomplete, there is not replacement parts.
  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

      : GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch ON.
    2. Check DTC.

      Is DTC detected? 

      YES: Proceed to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals