Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2014 >> Juke SL, FWD, Automatic CVT Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0130 To P0420 >> DTC P0196: EOT Sensor >> Component Inspection

Component Inspection

  1. CHECK ENGINE OIL TEMPERATURE SENSOR 
    1. Turn ignition switch OFF.
    2. Disconnect engine oil temperature sensor harness connector.
    3. Remove engine oil temperature sensor.
    4. Check resistance between engine oil temperature sensor terminals by heating with hot water as shown in the figure below.
      Engine oil temperature sensor Condition Resistance (kΩ)
      + -
      Terminal
      1 2 Temperature [°C (°F)] 20 (68) 2.37 - 2.63
      50 (122) 0.68 - 1.00
      90 (194) 0.236 - 0.260
      Fig 1: Heating ECT Sensor In Hot Water
      G09242896Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace engine oil temperature sensor. Refer to "EXPLODED VIEW ".