Diagnosis Procedure
- CHECK START
Check front and rear brake force distribution using a brake tester.
Is the inspection result normal?
YES: GO TO 2
NO: Check brake system.
- CHECK FRONT AND REAR AXLE
Make sure that there is no excessive play in the front and rear axles. Refer to front: "INSPECTION ", rear: "ON-VEHICLE SERVICE ".
Is the inspection result normal?
YES: GO TO 3
NO: Repair or replace malfunctioning components.
- CHECK WHEEL SENSOR AND SENSOR ROTOR
Check the following:
- Wheel sensor installation for damage
- Sensor rotor installation for damage
- Wheel sensor connector
- Wheel sensor harness
Is the inspection result normal?
YES: GO TO 4
NO:
- Replace wheel sensor "REMOVAL AND INSTALLATION - FRONT WHEEL SENSOR " or "REMOVAL AND INSTALLATION - REAR WHEEL SENSOR ".
- Replace sensor rotor "REMOVAL AND INSTALLATION - FRONT SENSOR ROTOR " or "REMOVAL AND INSTALLATION - REAR SENSOR ROTOR ".
- Repair harness.
- CHECK ABS WARNING LAMP DISPLAY
Make sure that the ABS warning lamp is turned off after the ignition switch is turned ON or when driving.
Is the inspection result normal?
YES: Inspection End.
NO: Perform self diagnostic result. Refer to "CONSULT FUNCTION (ABS) ".