Removal and Installation: Notes

CAUTION:

When replacing the ABS actuator and electric unit (control unit), the calibration of the ABS actuator and electric unit (control unit) is required. Refer to "DESCRIPTION ".
Before servicing, disconnect the battery cable from negative terminal.
To remove brake tubes, use a suitable tool (flare nut wrench) to prevent flare nuts and brake tubes from being damaged. To install, use suitable tool (flare nut torque wrench).
Do not apply excessive impact to ABS actuator and electric unit (control unit), such as by dropping it.
Do not remove and install ABS actuator and electric unit (control unit) by holding harness.
After work is completed, bleed air from brake tubes. Refer to "BLEEDING BRAKE SYSTEM ".
After installing harness connector on the ABS actuator and electric unit (control unit), make sure connector is securely locked.

NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.