Component Inspection

CHECK GEAR LEVER POSITION SENSOR-I
1. Turn ignition switch OFF.
2. Disconnect gear lever position sensor harness connector.
3. Remove the sensor. refer to "EXPLODED VIEW ".
4. Visually check the sensor for chipping.
  Is the inspection result normal?
  
  YES: GO TO 2.
  
  NO: GO TO 3.
  
  Fig 1: Checking Gear Lever Position Sensor-I
  Courtesy of NISSAN NORTH AMERICA, INC.

CHECK GEAR LEVER POSITION SENSOR-II

Check resistance between gear lever position sensor terminals as per the following items.

Terminals (Polarity)	Resistance (Ω)
1 (+) - 2 (-)	Except 0 or ∞ [at 25°C (77°F)]
1 (+) - 3 (-)
1 (+) - 4 (-)
2 (+) - 3 (-)
2 (+) - 4 (-)
3 (+) - 4 (-)

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 3.

REPLACE GEAR LEVER POSITION SENSOR
Replace gear lever position sensor. Refer to "EXPLODED VIEW ".

: INSPECTION END