Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2013 >> Xterra PRO-4X, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Diagnostic Codes & Symptom Tests) >> DTC/Circuit Diagnosis >> DTC P0451: EVAP Control System Pressure Sensor >> Component Inspection >> EVAP Control System Pressure Sensor

EVAP Control System Pressure Sensor

  1. Remove EVAP control system pressure sensor with its harness connector.

    Do not reuse the O-ring, replace it with a new one. 

  2. Install a vacuum pump to EVAP control system pressure sensor.
  3. Turn ignition switch ON and check output voltage between ECM terminal 102 and ground under the following conditions.
    Applied vacuum kPa (kg/cm2 psi) Voltage V
    Not applied 1.8 - 4.8
    -26.7 (-0.272, -3.87) 2.1 to 2.5V lower than above value
    CAUTION:
    • Always calibrate the vacuum pump gauge when using it.
    • Never apply below -93.3 kPa (-0.952 kg/cm2 , -13.53 psi) or pressure over 101.3 kPa (1.033 kg/cm2 , 14.69 psi).
  4. If NG, replace EVAP control system pressure sensor.
scientia non olet · About Mike's Workshop Manuals