Front Power Window Motor LH Circuit Check

1. Turn ignition switch OFF.
2. Disconnect front power window motor LH.
3. Turn ignition switch ON.
4. Check voltage between front power window motor LH connector D8 and ground.

   Terminal			Main power window and door lock/unlock switch condition	Voltage (Approx.)
   (+)		(-)
   Front power window motor LH connector	Terminal
   D8	1	Ground	UP	Battery voltage
   			DOWN	0
   	3		UP	0
   			DOWN	Battery voltage

   Is the inspection result normal? 

   YES: GO TO  3.

   NO: GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect main power window and door lock/unlock switch.
3. Check continuity between main power window and door lock/unlock switch connector D11 and front power window motor LH connector D8.

   Main power window and door lock/unlock switch connector	Terminal	Front power window motor LH connector	Terminal	Continuity
   D11	17	D8	1	Yes
   	19		3

4. Check continuity between main power window and door lock/unlock switch connector D11 and ground.

   Main power window and door lock/unlock switch connector	Terminal	Ground	Continuity
   D11	17		No
   	19

   Is the inspection result normal? 

   YES: Replace main power window and door lock/unlock switch. Refer to "REMOVAL AND INSTALLATION ". After that, refer to "WORK PROCEDURE ".

   NO: Repair or replace harness.

Check front power window motor LH.

Refer to "DRIVER SIDE: COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".

NO: Replace front power window motor LH. Refer to "REMOVAL AND INSTALLATION ". After that, refer to "WORK PROCEDURE ".