Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2013 >> Murano SL, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS U0101 To P0183 (Except CROSSCABRIOLET) >> DTC P0130, P0150: A/F Sensor 1 >> Component Function Check

Component Function Check

  1. PERFORM COMPONENT FUNCTION CHECK 

With GST 

  1. Start engine and warm it up to normal operating temperature.
  2. Drive the vehicle at a speed of 80 km/h (50 MPH) for a few minutes in the suitable gear position.
  3. Shift the selector lever to the D position, then release the accelerator pedal fully until the vehicle speed decreases to 50 km/h (31 MPH).
    CAUTION: Always drive vehicle at a safe speed.
    NOTE: Never apply brake when releasing the accelerator pedal.
  4. Repeat steps  2 and  3 for 5 times.
  5. Stop the vehicle and turn ignition switch OFF.
  6. Wait at least 10 seconds and restart engine.
  7. Repeat steps  2 and  3 for 5 times.
  8. Stop the vehicle.
  9. Check 1st trip DTC.

    Is 1st trip DTC detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals